Ohaus JR Series Electronic Balances - Manual (Page 8)

8
Pan and Pan Support Pan and Pan Support Pan and Pan Support Pan and Pan Support Pan and Pan Support
Square Pan Square Pan Square Pan Square Pan Square Pan
Insert the pan support into the hole in the
weighing mechanism as shown in the il-
lustration. Make sure the hole in the pan
support faces the rear of the balance.
Once installed, the pan support should not
rotate.
The pan has a guide pin which protrudes
from the bottom. Place the pan on the
support making sure the guide pin is in-
serted in the hole in the pan support.
AC Adapter AC Adapter AC Adapter AC Adapter AC Adapter
Plug the molded connector of the adapter
into the receptacle at the rear of the bal-
ance. Plug the adapter into a convenient
AC outlet. When power is applied to the
balance, it will begin a self test cycle.
During this time, the display will count
down from 10 and display the word CHEC.
PAN
SUPPORT
Round Pan Round Pan Round Pan Round Pan Round Pan
Insert the pan support into the hole in the
weighing mechanism.
Place the pan on the support.
SUPPORT
PAN
AC ADAPTER
RECEPTACLE