Ohaus JR Series Electronic Balances - Manual (Page 25)

25
End End End End End
You must use END to exit the Setup menu.
Changes you make in the Setup menu
Changes you make in the Setup menu Changes you make in the Setup menu Changes you make in the Setup menu Changes you make in the Setup menu
are only stored in memory if you use
are only stored in memory if you use are only stored in memory if you use are only stored in memory if you use are only stored in memory if you use
END.
END. END. END. END.
To exit the Setup menu and store your
settings, press when END is dis-
played.
When is released, the balance will
be returned to normal weighing opera-
tions.
5. To lock out the other menus, press
and repeat the procedure in
steps 3 and 4.
OFF OFF OFF OFF OFF
MODE MODE MODE MODE MODE
ON ON ON ON ON
TARE TARE TARE TARE TARE
ON ON ON ON ON
TARE TARE TARE TARE TARE
MENU LOCK-OUT PROTECTION MENU LOCK-OUT PROTECTION MENU LOCK-OUT PROTECTION MENU LOCK-OUT PROTECTION MENU LOCK-OUT PROTECTION
Access to the Calibration, User, and Setup
menus, can be disabled using the lock out
switch located under the right side of the
balance, near the display.
1. Turn the display off and unplug the
power cord.
2. Slide the balance toward you, with
the front over the edge of a table.
(You can also turn the balance on its
left side, but if you do, you MUST
remove the pan and spill ring first!)
3. Locate hole under display where
switch is located.
4. Using a small screwdriver, slide the
switch forward for LOCKED or back
for UNLOCKED.
5. Plug in the power cord and turn on the
balance.
LOCK OUT
SWITCH
LOCK
UNLOCK