Ohaus JR Series Electronic Balances - Manual (Page 12)

12
To access a menu, press and hold until desired menu appears, then release it.
Original factory default settings are shown in boldface type.
Use these buttons to step through menus and select submenus:
next select
selection displayed item
ON ON ON ON ON
TARE TARE TARE TARE TARE
OFF OFF OFF OFF OFF
MODE MODE MODE MODE MODE
ON ON ON ON ON
TARE TARE TARE TARE TARE
CAL
SPAN
LIN
END
PRINT
USING MENUS TO CONFIGURE THE BALANCE USING MENUS TO CONFIGURE THE BALANCE USING MENUS TO CONFIGURE THE BALANCE USING MENUS TO CONFIGURE THE BALANCE USING MENUS TO CONFIGURE THE BALANCE
Precision Standard balances contain four display menus which enable you to calibrate
and configure the balance for your specific operating requirements.
Calibration Menu: Calibration Menu: Calibration Menu: Calibration Menu: Calibration Menu: Used to calibrate the balance for span or linearity.
User Menu User Menu User Menu User Menu User Menu: Used to adapt balance to environmental condtions.
Setup Menu: Setup Menu: Setup Menu: Setup Menu: Setup Menu: Used to enable, disable or customize different balance features.
Print Menu: Print Menu: Print Menu: Print Menu: Print Menu: Used to configure the RS232 interface.
SEL
g, dwt, ct, oz, ozt, GN,
taels 1,2,3, mommes,
lb, lb:oz
Sr
LOCSW
Calibration
User
Setup
Print
End
END
NOTE:
PRINT menu appears only
when RS232 option is in-
stalled.
USER
RESET
AL
0, 1 1 1 1 1, 2, 3
STB
.5d, 1d 1d 1d 1d 1d, 2d, 5d
AUTO- 0
OFF, .5d .5d .5d .5d .5d, 1d,3d
END
SETUP