MSD 32079 Red Super Conductor Gen III LS-1_6 V8, Universal Installation - Manual

Parts Included In This Kit:
8 - Spark Plug Wires with 90° and Multi-Angle Boots
9 - LS1 Boots and Terminals
1 - Mini-Stripper-Crimper
9 - Terminal Insert Guides
Universal Wire Set for GM
GEN III Engines
PN 32079 / PN 32073
This Universal Wire set gives you the choice of using a 90° or straight/Multi-Angle boot and
terminal on the spark plug to accommodate for the header variances. Once you have determined
the style boots to use, you can cut the new wires to length then install the correct supplied coil
terminal and boot. A Mini-Stripper-Crimper Tool is supplied to help you achieve a strong, factory
type crimp.
Figure 1 Choosing the Spark Plug Boots and Terminals.
Figure 2 Stripping the Sleeve.
Tools Required:
Razor Blade
Vise (4" Minimum)
Needlenose Pliers
Optional:
PN 35051 Pro Crimp Tool
1. Once you’ve determined wire length and spark plug
boot to use, position the wire in the corresponding strip
guide of the strip tool.
2. There are two stripping positions on the stripping slot,
when installing the LS1 terminal it will require you to strip
the wire at standard terminal length (Figure 2).
3. Remove the wire and twist the cut sleeve off in a coun-
terclockwise direction.
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4