MSD 8384 Ford 351W Dual Pickup Distributor Installation User Manual
Msd pro-billet dual pickup ford distributor
AUTOTRONIC CONTROLS CORPORATION
• 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
MSD Pro-Billet Dual Pickup Ford Distributor
PN 8380; 351C-460, PN 8384; 351W
PN 8382; 289/302
Important:
Read these Instructions before attempting the installation.
Parts Included:
1 - Pro-Billet Distributor
1 - O-ring Seal
1 - Rotor, PN 8423
1 - Tube of Gear Lubricant
1 - Distributor Cap, PN 8408
2 - 1.5" Self Tapping Screws
1 - Advance Kit
1 - Wire Retainer
Note: The Dual Pickup Distributors must be used with an MSD Ignition Control(s).
TIMING FUNCTIONS
Before continuing with the installation, here are a few definitions you should be aware of:
Initial Timing: This is the base timing (also referred to as idle timing) of the engine before the
centrifugal advance begins.
Centrifugal Advance: The centrifugal (or mechanical) advance mechanism is made up of weights,
springs, advance cams, and an advance stop bushing. The amount and rate of advance that
your distributor is capable of is determined by the centrifugal timing. If you ever wish to lock out
the centrifugal advance, refer to the centrifugal advance section.
Total Timing: This is the total of the initial timing plus the centrifugal advance added together.
Example: 10° Initial + 25° centrifugal = 35° Total Timing.
Note: MSD Distributors are supplied with the heavy (slow) advance springs installed. This is to
prevent detonation in certain applications. Review the information on pages 2-3 to
determine the best advance curve for your application.