Focus Foodservice West Bend Commercial Aluminum Coffeemakers - Use & Care es User Manual

Page 6

unit well (where the stem fits) with the special cleaning tool provided and a

scouring pad. Twist the pad inside the heating unit well to clean. The heating

unit well must be kept clean for coffeemaker to work properly. Rinse with

warm water after cleaning and dry.

4. Clean the outside of the coffeemaker with a damp cloth and dry with a soft cloth.

Do not use abrasive metal scouring pads or cleansers on the outside of the

coffeemaker because scratching will occur.

PECIAL

LEANING

–

EVERY TWO WEEKS

If coffeemaker is used daily, a special cleaning every 2 weeks, or every week if

it is used for heating water, is necessary to thoroughly clean the heating unit

well. If not kept clean, the coffeemaker will not work properly.

1. Fill the coffeemaker with 1 quart EACH of water and white distilled vinegar. (If a

white mineral buildup has formed on the inside of coffeemaker, use an additional

2 cups of vinegar). Place the stem and empty basket in place and lock the cover

onto the coffeemaker. If applicable, set the “ON/OFF” switch to “ON.” Allow the

coffeemaker to complete the perking cycle, then let stand for 20 minutes.

2. Turn “OFF” and unplug the cord from the outlet. Drain the coffeemaker and allow

it to cool. Wash the inside and the parts following the regular cleaning

instructions, making sure to thoroughly clean the heating unit well.

3. If applicable, clean the coffee level view tube with a soft brush. Unscrew the

gauge cap and lift out the tube. Wash in warm, soapy water with a brush and

rinse. Replace the tube and secure with the gauge cap.

4. To clean the faucet, unscrew the handle. Move a small brush up and down

through the faucet, then insert the brush through the opening on the inside of the

coffeemaker to clean the faucet connection. Wash the faucet handle in warm,

soapy water and rinse. Replace the faucet.

DO NOT USE BAKING SODA TO CLEAN THE COFFEEMAKER BECAUSE IT

CAN DISCOLOR AND PIT THE METAL.

To Remove Discoloration: Inside of the coffeemaker can discolor when used for

heating water, which is normal. To remove/lighten discoloration, fill coffeemaker with

water to the level of discoloration (at least to the minimum cup level, but not past

maximum cup level). Place stem and empty basket in place. For every 12 cups of

water added to coffeemaker, add 2 teaspoons cream of tartar to basket. Secure

cover onto coffeemaker, plug cord into coffemaker and then into outlet and allow

coffeemaker to complete perk cycle. Let stand for 15 to 20 minutes or until

discoloration is lightened. Unplug cord and drain coffeemaker. Allow to cool and

follow general cleaning instructions.