EVS XT3 Version 11.02 - July 2013 Configuration Manual - Manual (Page 73)

3.2.4. SLSM Configurations
Introduction
SLSM Principles
This section details the available multi-phase SLSM configurations on XT3 servers.
In SLSM configurations, a supermotion recorder of a two- or three-phase camera accounts
for one logical channel, but corresponds respectively to two or three physical channels.
In 3G SLSM configurations, a supermotion recorder of a two-phase camera corresponds
to one logical channel, and is cabled on the primary link of a codec module. It however
uses both primary and secondary links of that codec module on the V3X board.
In U-Motion configurations, an ultramotion recorder of a six- or ten-phase camera
accounts for one logical channel, but corresponds respectively to six to ten physical
channels.
Overview on Configurations
The tables in the following sections show the available SLSM and U-Motion
configurations with an XT3 6U server and XT3 4U server, and how the BNC connectors
should be cabled.
The XREC configurations, presented at the end of the tables, make use of the secondary
link of the codec module of a record channel as an independent recorder. See also the
section "Channel Assignment in XREC Configurations" on page 57.
Note
Specific SLSM configurations for 1080p/3D dual link and 3G configurations are
presented in the section "3D/1080p SLSM Configurations" on page 83.
XT3 4U Servers
Available Configurations with SLSM 2-Phase Cameras
IN4/OUT1 IN3/OUT2 IN2/OUT3 IN1/OUT4
#REC
SLSM
2x
#
REC #
PLAY Prim.
Link Sec.
Link Prim.
Link Sec.
Link Prim.
Link Sec.
Link Prim.
Link Sec.
Link
1 0 0 REC1,2 REC1,1
1 1 0 REC2 REC1,2 REC1,1
1 2 0 REC3 REC2 REC1,2 REC1,1
2 0 0 REC2,2 REC2,1 REC1,2 REC1,1
1 0 1 PLAY1 MIX1 REC1,2 REC1,1
CONFIGURATION MANUAL XT3 Server 11.02
3. Multicam Configuration 65