EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 94)

Vertical Interp. (Vertical Interpolation)
Description Enables or disables the two-line interpolation process.
Values • No (default)
• Yes
Four Lines
Description Enables or disables the four-line interpolation process.
Values • No (default)
• Yes
3.3.5. PC LAN Settings
Introduction
The PC LAN settings are displayed on the Server tab in the server-based application
(1st page) and web-based interface in the advanced mode.
The PC LAN settings are highlighted in the screenshot of the server-based application
shown below:
Note
The PC LAN settings are read-only in the Multicam Configuration window. You
can modify them in the Multicam Setup window, using the Set LAN PC address
command. See section "Setting the Server LAN PC Address" on page 25 for
more information.
XT2 Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 84