EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 32)

2.3. Server Parameters
2.3.1. Chapter Contents
The table below presents the topics of this section and shows whether the described
features are available from the web-based interface and/or from the server-based
interface.
Commands Page
Server-
Based Web-
Based
"Assigning a Server Facility Name" 2.3.2 Yes Yes
"Activating and Deactivating the Password
Protection" 2.3.3 Yes No
"Setting the Server LAN PC Address" 2.3.4 Yes No
"Setting the Server Date and Time" 2.3.5 Yes No
"Setting the Default Output To VGA/Video" 2.3.6 Yes No
"Configuring Server Raids" 2.3.7 Yes No
2.3.2. Assigning a Server Facility Name
Introduction
You can assign a facility name to the EVS server. It allows the identification of the EVS
server with a dedicated name, besides the server's serial number. This name is
independent from any configuration.
The server facility name differs from the server net name, which can vary from a
configuration to the other as it is defined in the configuration parameters.
The server facility name is displayed in the title bar of the Multicam setup and
configuration windows, as well as on the OSD (on-screen display).
XT2 Server - Version 11.01 - Configuration Manual
2. Multicam Setup 22