EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 30)

2.2.6. Changing the Position of Configuration Lines
In the Server-Based Application
To move a configuration line up in the list in the server-based application, proceed as
follows:
1. Press the UP ARROW or DOWN ARROW key to respectively move up and down in
the list of configuration lines until the requested line is highlighted.
2. Do one of the following:
◦ To move the selected line up, press CTRL + UP ARROW.
◦ To move the selected line down, press CTRL + DOWN ARROW.
In the Web-Based Interface
The feature to move configuration lines up and down in the list of configuration lines is not
available as such in the web-based interface.
You can however use the import and export feature to change the position of lines in the
list of configuration lines.
2.2.7. Copying, Pasting and Deleting Configuration
Lines
How to Copy/Paste Configuration Lines
In the Server-Based Application
Warning
Note that copying a line onto another position will erase the configuration on the
selected position.
To copy and paste a configuration line in the server-based application, proceed as follows:
1. Press the UP ARROW or DOWN ARROW key to respectively move up and down in
the list of configuration lines until the requested line is highlighted.
2. Press CTRL+C to copy the line to the clipboard.
3. With the UP ARROW and DOWN ARROW keys, move to the position where you
want to copy the line.
4. Press CTRL + V to paste the line to the selected position.
5. Press ENTER to confirm that you agree to replace the former configuration line by the
one copied on the selected position.
XT2 Server - Version 11.01 - Configuration Manual
2. Multicam Setup 20