EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 202)

Push Target
Description Specifies which EVS servers will be listed as possible targets
for push actions when the user selects:
• the default Target 1 and Target 2 in the settings, or
• a target for a specific push action if no default target has
been configured.
Values The following values are possible:
• SDTI:
Only SDTI targets will be listed. The servers are listed by
their network system name and number.
• Gigabit:
Only EVS servers reachable via the GigE network and not
present on the same SDTI network will be listed. The
servers are listed by their GigE server name, and IP
Address.
• SDTI+Gigabit:
First the servers on the same SDTI network connected
through SDTI are listed, then the servers not on the same
SDTI network but reachable via the GigE network are
listed.
The Gigabit and SDTI+Gigabit values are not available if the
EVS server does not have a GigE board.
Default Value SDTI
XT2 Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 192