AASTRA 600d for OpenCom 1000 User Guide (with bookmarks) EN User Manual

Page 83

Devices menu

Change barring

This function is used to restrict access to external lines for two user groups (=
outward restricted or local calls only). Once external line access rights have
been restricted, the terminals of the user group in question can still be reached
by external incoming calls, but their external access rights are restricted (out-
ward restricted = no external calls can be made; local calls = only local calls can
be made). If needed, contact your system administrator to find out the user
groups for which the “Change barring” feature has been set up and which
access level is involved.

Central config. > Subscriber serv.
The settings in this menu require a subscriber service password.

Call diversions

This function allows you to set up call diversions for the call numbers of other
internal subscribers (individual INTERNAL/EXTERNAL keys or for the phone in
general). You can also program a call diversion for user groups. You can pro-
gram external call diversions to any subscribers in the public network. Enter the
internal call number you want to divert. The rest of the procedure is identical to
the one used for programming a call diversion for a device (see page 69).

Hunt group

This menu entry allows you to switch a call number out of an existing user
group and back in again. You can carry this switch for every internal subscriber
in the user group. Enter the internal call number for which you want to switch
the user group on or off.

Call blocking

This function allows you to activate and deactivate call blocking for the call
numbers of other internal subscribers (individual INTERNAL/EXTERNAL keys or
for the phone in general) and for the call numbers of parallel user groups. Enter
the internal call number for which you want to switch call blocking on or off.

Trunk acc. level

This setting allows you to change the basic trunk line access level for every
phone. Enter the internal call number for which you want to change the trunk
line access rights. Select the access level and activate it with “on”. Eight diffe-
rent levels can be configured:
0 = Internal calls only, 1 = Outward restricted, 2 = Local calls only, 3 = Local
calls and adjoining areas only, 4 = National calls, 5 = International calls, 6 =
Reserved, 7 = Reserved