AASTRA 600d for OpenCom 1000 User Guide (with bookmarks) EN - Manual (Page 12)

6
Installation
Installing/removing a mounting bracket or rotary clip
Aastra 610d, 620d
Place the supplied fixing bracket on both openings at
the upper end of the handset and snap in place by
pressing downwards. To remove the fixing bracket,
press into the small cutouts at the edge of the bracket
and pull the two sides slightly apart.
The Aastra 610d and 620d can also be fitted with
a rotary clip as an accessory. Place the supplied fixing
bracket on both openings at the upper end of the
handset and snap in place by pressing downwards. The
clip is then pushed onto the protruding button. To
release the handset from the clip, press the top button.
Attaching the carrying strap
Aastra 610d, 620d: There are two openings
in the upper part of the fixing bracket. Feed the lower
end of the carrying strap through these openings (ple-
ase install with the fixing bracket removed). Carrying
straps are available as accessories (see page 101).
Aastra 630: A carrying strap with carrying strap
attachment is available as an accessory. To
attach the holder, replace the screwed-on belt
clip by the carrying strap attachment.