Bosch PFS 105 E WALLPaint - Manual (Page 17)

English | 17
Bosch Power Tools 1 619 929 K18 | (18.11.11)
Adjusting the Spray Pattern (see figure E)
f
Never actuate the trigger switch 9 while adjusting the
air cap 3.
– Adjust the desired spray-jet width using adjusting lever 2.
– Turn the air cap 3 to the requested position.
Adjusting the Spraying Capacity (see figure F)
– To adjust the requested spraying capacity, turn the thum-
bwheel 7:
I: Min. spraying capacity,
IIII: Max. spraying capacity.
Adjusting the Air Flow (see figure G)
– Turn control knob 24 to adjust the air flow and the pres-
sure for the spray material being used.
It is recommended to start with the maximum air flow.
Work Breaks and Transport (see figure H)
During work breaks, the spray gun 1 can be placed into the
set-down port 25. The holding device ensures that the spray
gun is tightly seated in the set-down port. Spray material can-
not run out or escape.
– Place down the spray gun on the set-down port and push in
against the resistance until tightly seated.
The base unit comprises a carrying handle for easy transport
of the fine-spray system.
– Completely empty the container 10.
Make sure that the spray gun 1 contains no more paint:
Spray the spray gun empty.
– Place down the spray gun on the set-down port and push in
against the resistance until tightly seated.
Application Adjusting lever 2 Air cap 3 Spray jet pattern
Initial coatings, corners, edges
and hard to reach locations
Vertical compact jet for hori-
zontal coating direction
Horizontal compact jet for
vertical coating direction
Large-surface top coatings
Vertical wide jet for horizon-
tal coating direction
Horizontal wide jet for verti-
cal coating direction
Spraying capacity Adjustment
Too much material on target
area:
The spraying capacity must
be reduced.
– Turn the thumbwheel 7 in
direction I.
Not enough material on target
area:
The spraying capacity must
be increased.
– Turn the thumbwheel 7 in
direction IIII.
Minimal air flow Maximum air
flow
Air Flow Adjustment
Too much fog of coating
material:
The air flow must be re-
duced.
– Turn control knob 24 to-
ward the left.
Atomisation too coarse: The air flow must be in-
creased.
– Turn control knob 24 to-
ward the right.
OBJ_BUCH-1543-001.book Page 17 Friday, November 18, 2011 9:16 AM