Garmin GPSMAP 376C - Manual (Page 138)

No Diff GPS Location—RTCM is selected but the unit is not receiving DGPS
data.
No Roads Near Destination—the destination for the road route you tried to
calculate is not near any roads. Select a different destination.
No Roads Near Starting Point—the start location for the road route you tried
to calculate is not near any roads. Select a different start location.
No DGPS Position—no differential connection data is available, or not enough
data is available to calculate a DGPS position.
No Tide Stations for that Area—no tide stations within 100 miles of the area.
No XM Signal—the GXM 30 antenna is not receiving an XM signal.
None Found—no data matched the search criteria.
Off Course—you are off course by the distance set in the Off Course Alarm.
Proximity Memory Full—no additional proximity waypoints can be saved.
Proximity Radius Overlaps—the radius of two proximity waypoints overlap.
Route Already Exists—you have entered a route name that already exists.
Route Calculation Error—no route can be calculated.
Route Memory Full—no additional routes can be saved.
Route Truncated—uploaded route from another device has more than 300
waypoints.
Route Waypoint Memory Full—no additional route waypoints can be saved.
Saving XM Program Information—an XM Radio channel lineup change has
occurred and the unit is saving the channel lineup to memory.
Shallow Water—the water is shallower than the amount set in the Shallow
Water Alarm.
Sonar Failed Unit Needs Repair—there is an internal problem with the unit.
Contact Garmin Product Support to have the unit serviced.
Sunrise, Switching to Day Mode—the unit is switching to Day Mode.
Sunset, Switching to Night Mode—the unit is switching to Night Mode
Thunderstorm Warning—a severe thunderstorm warning was issued for the
area by the National Weather Service.
Tornado Warning—a tornado warning was issued for the area by the National
Weather Service.
Track Already Exists—a saved track with the same name already exists.
Track Log Full—the track log is full and track recording was turned off.
To record more track points, you need to clear the track log and turn track
recording on.
Track Memory Full—no more track data can be stored. Delete the old track
data to store the new data.
Track Truncated—a complete uploaded track will not fit in memory. The
oldest track log points have been deleted.
Transducer Disconnected, Sonar Turned Off—the unit has no transducer
attached, has a bad cable/transducer, or has a disconnected transducer cable.
Transfer Complete—data transfer was completed.
USB Connected—the USB cable was recently plugged in.
130 GPSMAP 376C Owner’s Manual
A
PPendIX
> M
essAges