ACU-RITE ENC 250SS - Manual (Page 20)

Acu-Rite Companies Inc.
ENC 250™ SINGLE SECTION
Tools
Tool Requirements
You will need the following tools to complete the installation:
• 0.001” Dial Indicator with Magnetic Base
• English Hex Wrench Set
• Metric Hex Wrench Set
• Dial Calipers
• Feeler Gage
• Hand Drill
• Hand Tap
• Taps(English): 1/4-20 UNC & #8-32 UNC
• Taps(Metric): M6, M4
• Drills(English): #7 (.201”), #29 (.136”), N (.302”)
• Drills(Metric): 5mm, 3.3mm, 7.7mm
• Reamer(English): .312”
• Reamer(Metric): 8mm
• Transfer Punch Set
• Hammer
• Center Punch
• Phillips Screw Driver
• Flat-tip Screw Driver
* NOTE: Both English and metric mounting hardware have
been supplied. The mounting instructions reference to both.
Tools required depend on the fasteners being used.
18