ACU-RITE SENC 150 - Manual (Page 5)

Please follow these preparation guide lines.
• Understand your mounting requirements.
• Mount with lip seals down and away from the work area.
• Brackets should be kept as short as possible and rigid.
• Surfaces must be in good condition, clean, and free of dirt.
Remove paint from machined mounting surfaces.
• Alignment brackets must not be removed until instructed.
• Machine travel can not exceed the encoder measuring length.
• Either limit machine travel or obtain correct length scale.
• Never mount with lip seals upward or towards work area.
3
SENC 150 Mounting Preparation
“L” = Measuring length + 1.75” nominal over travel
“L”
1.150 1.150
Cable direction
• Determine cable exit direction before installing the encoder.
• To change the cable exit direction; remove the cover plate and
rotate the cable 180°.
T-10 Torx screw (2)
Plug
Cover plate
Vinyl cable grommet
Armor cable hex crimp
ACU-RITE ®
516291-21_Ve00_SENC_150.indd 5 10/22/2009 10:00:39 AM