ACU-RITE SENC 150 - Manual (Page 15)

• Insert the encoder into the spar.
• Center the encoder from end to end with the spar.
• Lock in place by tightening the M4 set screws.
• Attach the bracket to the machine.
• Align the reading head mounting holes with the bracket holes.
• Attach head to bracket / Set leveling screws / Secure fasteners.
• To locate the reading head bracket, attach it to the reading head.
• Center the axis and mark the bracket mounting holes.
• Remove the bracket, drill / tap holes for 1/4-20 (M6).
M4 x 8mm set screws
8-32 x 5/8” SHCS
(M4 x 16mm)
Do not tighten prior to adjusting
leveling set screws.
Reading head bracket
8-32 x 5/8” SHCS
(trim if necessary)
SENC 150 Spar Installation Procedure
• Slide the brackets away from the reading head.
• Remove the alignment brackets and save for future use.
• Proceed to page 13, “Checking Your Installation”.
Alignment bracket
removal
Slide brackets away from reading head and cable.
Twist 45°
13
ACU-RITE ®
516291-21_Ve00_SENC_150.indd 15 10/22/2009 10:00:45 AM