Acura 2010 ZDX - Manual (Page 83)

If you do not fasten your seat belt,
you will also see a
‘‘FASTEN SEAT
BELT ’’ message on the multi-
information display when you turn
the ignition switch to the ON (II)
position.
These messages go off in several
seconds after the key is inserted into
the ignition switch.
On models with keyless access
system
These messages go off in several
seconds.
Models equipped with the keyless
access system have an engine start/
stop button instead of an ignition
switch. ON mode is the equivalent of
ON (II). See page
196 for ignition
switch and power mode comparison.
With the ignition switch in the ON
(II) position, the multi-information
display changes as shown on page
81
each time you press the INFO
(
▲/▼) button or the SEL/RESET
button.
When you turn the ignition switch to
the ON (II) position, your last
selection is displayed.
SEL/RESET BUTTON
On models with
adaptive cruise control (ACC)
INFO BUTTON ( ▲/▼)
CONTINUED
Multi-Information Display
79
Instruments
and
Controls
2010 ZDX