Acura 2010 ZDX - Manual (Page 70)

U.S. Canada Parking Brake
and Brake
System Indicator
This indicator has two functions:
1. It comes on when you turn the
ignition switch to the ON (II)
position. It is a reminder to check
the parking brake. Driving with
the parking brake not fully
released can damage the rear
brakes, axles, and tires.
If you drive without releasing the
parking brake, a beeper will
sound, and you will also see a
‘‘RELEASE PARKING BRAKE’’
message on the multi-information
display (see page
90 ).
2. If it stays on after you have fully
released the parking brake while
the engine is running, or if it
comes on while driving, it can
indicate a problem in the brake
system. You will also see a
‘‘LOW
BRAKE FLUID ’’ or ‘‘CHECK
BRAKE SYSTEM ’’ message on the
multi-information display (see
pages
90 ). For more information,
see page 594 .
Models equipped with the keyless
access system have an engine start/
stop button instead of an ignition
switch. ON mode is the equivalent of
ON (II). For more information, see
pages
194 and 196 .
Supplemental Restraint
System Indicator
This indicator comes on briefly when
you turn the ignition switch
ꭧ to the
ON (II) position. If it comes on at any
other time, it indicates a potential
problem with your front airbags. This
indicator will also alert you to a
potential problem with your airbag
system components. You will also
see a
‘‘CHECK AIRBAG SYSTEM’’
message on the multi-information
display (see page
90 ). For more
information, see page 34 .
ꭧ: Models equipped with the
keyless access system have an
engine start/stop button instead of
an ignition switch. ON mode is the
equivalent of ON (II), and START
mode is the equivalent of START
(III). For more information, see
pages
194 and 196 .
Instrument Panel Indicators
66
2010 ZDX