ACR&Artex C406-1 - Manual (Page 69)

25-62-10
Page 69 of 90
JUL 31/12
ACR ELECTRONICS, INC / ARTEX PRODUCTS
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
C406-1 (453-5002), C406-1HM (453-5003)
(c) Insert the buzzer power and ground wires in Pin 2 (+) and Pin 4 (–) of the receptacle,
respectively.
Figure 22. Remote Switch Harness Arrangement at ELT End
SUBTASK 25-62-10-450-003
D. Cockpit Remote Switch 9-Pin Plug Installation
(1) Inert the wiring pins in the 151-5009 Molex 9-pin cockpit remote switch plug. See "Figure 21.
Remote Switch Harness Wiring Diagram”, on page 67.
(a) Insert each harness female pin into the plug.
NOTE: Refer to the wire identification and pin relationships recorded in Step C.(4)(b).
NOTE: Terminal pins may be removed from the plug using Molex extraction tool
11030002, or equivalent.
(b) Insert the remote switch power wire female pin into Pin 1 or Pin 3 of the plug, as
appropriate for the selected 14V or 28V power source.
(c) Insert the remote switch ground wire into Pin 9 of the plug.
PIN 1
12-PIN MOLEX
RECEPTACLE
NOTE: FEED THE WIRE BUNDLE THROUGH THE MOUNTING
FRAME CAP HOLE PRIOR TO INSERTING THE PINS INTO THE
RECEPTACLE
TO COCKPIT REMOTE
SWITCH AND GROUND