Acnodes FPC 7150 - Manual (Page 5)

IV
Important Safety Precautions
1. Before getting started, read these instructions and save them for later reference.
2. Please disconnect this equipment from any AC outlet before cleaning. Clean with
a damp or dry cloth only. Do not spray any liquid cleaner directly.
3. The power outlet socket used to plug in the computer power cord must be
located near the system and easily accessible. Do not use outlets on the same
circuit of the systems that are regularly switched on and off.
4. Do not expose the power cord, extension cord and power outlet to moisture or
traffic intensive walkways.
5. Install the equipment on a sturdy and reliable surface to prevent damage caused
by dropping.
6. If the Equipment is sharing an extension cord with other devices, make sure the
total ampere rating of the devices plugged into the extension cord does not
exceed the cord’s ampere rating.
7. If an operating system is not installed, an operating system must be loaded first
before installing any software into the equipment.
8. Disconnect the power cord from the computer before any installation of internal
components. Make sure both the computer and the external devices are turned
off. A sudden surge of power may damage sensitive components. Also make
sure the computer is properly grounded.
9. During installation of any internal components, be sure to ground yourself to
discharge any static electricity. Most electronic components are highly sensitive
to static electric charge. Use a grounding wrist strap and place all electronic
components in any static-shielded devices. If a wrist-grounding strap is not
available, ground your self by briefly touching an unpainted piece of metal.
10. If the equipment is equipped with a touch panel, avoid using sharp or metallic
objects to operate the touch panel. Scratches on the touch panel may cause
mal-calibration or serious damage to the panel.
11. The brightness of the flat panel display will decrease with use over long periods
of time. However, hours of use will vary depending on the application
environment.
12. FPC 71X0 is equipped with a touch panel, avoid using sharp or metallic objects to
operate the touch panel. Scratches on the touch panel may cause mal-calibration
or serious damage to the panel.
13. The LCD panel display is not resistive to shock or vibration. When disassembling
FPC 71X0, make sure the LCD panel is properly and securely installed.