HONDA 2011 CR-Z - Manual (Page 115)

114
Controls
Operating the Switches Around the Steering Wheel Wipers and Washers
Rear Wiper/Washer ■
The rear wiper and washer can be used when
the ignition switch is in ON
II .
Wiper Switch (OFF, ON) ■
The wiper operates intermittently after
completing a few sweeps.
Washer ( ■ )
Sprays while you rotate the switch to this
position.
Hold it to activate the wiper and to spray the
washer. Once released, it stops operating after
a few more sweeps.
Operating in Reverse ■
When you shift the transmission to
R with the front wiper activated, the rear wiper
operates automatically as follows even if its switch is off.
Front Wiper Position Rear Wiper Operation
INT (Intermittent) Intermittent
LO (Low speed wipe)
HI (High speed wipe)
Continuous
Wipers and Washers
If the wiper stops operating due to any obstacle
such as the build-up of snow, park the vehicle in a
safe place.
Rotate the wiper switch to OFF, and turn the
ignition switch to ACCESSORY or LOCK ,
then remove the obstacle.
The wiper motor is equipped with a breaker that
may stop motor operation temporarily to prevent
an overload. Wiper operation will return to normal
within a few minutes, once the circuit has returned
to normal.
ON: Intermittent
OFF
Washer
31SZT600book.indb 114 2010/04/28 13:41:51
2011 CR-Z