Edimax Technology WP-S1300 - Manual (Page 17)

Chapter II Using Projector Server
2-1 Switch the Projector Server On and Check IP address
When the connection between projector server and external display is
established, you can switch the display‟s power on, then press the „Power‟
button of projector server, which is located at the front of projector server.
You should be able to see the following image displayed on external display; if
not, please make sure the external display you used with projector server
acc
epts input video resolution „1024 x 768‟, and horizontal refresh rate „60Hz‟.
*
If you see above image shown on display for more than two minutes, please
press „Power‟ button to switch the projector server off, and then switch the
projector server on again. If this still happens, refer to chapter 4-2
„Troubleshooting‟ for possible solutions.