Edimax Technology PS-2207SUg - Manual (Page 44)

37
Parameters Description
Wireless
Function
You can select “Auto”, Enable” or “Disable” to manually
configure the wireless function.
Auto – “Auto” is the default setting of the server. At this
mode, the server will automatically decide to enable or
disable the wireless function. When the server starts up,
it will auto-detect if the LAN port is connected to an
active network by an Ethernet cable. If this is the case,
the server will run in Ethernet mode. If the server is not
connected to an active network by Ethernet cable, the
server will run in wireless LAN mode.
Users can plug the Ethernet cable to the server at the
first, after configuring the server features and wireless
settings; they can unplug the Ethernet cable to enable
the wireless connection. It makes the configuration
much easier without creating the wireless connection in
advance.
Enable – Enable wireless function only, the server’s
wireless LAN will be always enabled and Ethernet will
be always disabled.
Disable – Disable the wireless function, the server’s
wireless LAN will be always disabled and Ethernet will
be always enabled.
Mode
Infrastructure – This operation mode requires the
presence of an 802.11 Access Point or Router. All
communication is done via the Access Point or Router.
Ad-Hoc – Select this mode if you want to connect to
other wireless stations in the Wireless LAN network
without through an Access Point or Router.
Click <Apply> at the bottom of the screen to save the above configurations.