Edimax Technology NS-2502 - Manual (Page 7)

6
2. Copy button
The Copy button has two functions: (1) copy the content of one external USB mass
storage device to another attached storage device, and (2) reset the configuration
of the storage server to factory default settings.
z Copy USB mass storage device: When you press and hold the Copy button for 2
seconds, the storage server will beep for 0.5 second to hint that your command is
detected. At this time, you should release the Copy button immediately if you want to
copy the content of one external USB mass storage device to another attached
storage device. During the process of copy, the LED of corresponding USB port will
flash slowly. When the LED of corresponding USB port stops flashing and is lit steady,
the copy job is finished. If any error occurs during the process of copy, the LED of
corresponding USB port will flash very fast. The default source storage is USB1, you
can change the source storage by USB Copy settings in Web user interface of
storage server.
z Restore factory default settings: Please refer to the description of Release button.
Note: Before you trigger the USB Copy function by pressing the Copy button, make sure
that the destination folder has enough free space to store all data of the source USB mass
storage device.
Note: USB Copy function does not support length of file name longer than 255 bytes. If the
source USB mass storage device contains any file with file name longer than 255 bytes,
the copy job will fail.
3. USB1
The USB1 port allows you to share your files stored in the USB mass storage device
plugged in.
Note: Please plug the external power of your USB mass storage devices before you
connect them to the storage server.
Note: If you have USB mass storage device (like USB external HDD), please plug it to
this storage server’s USB 2 port, and plug the USB flash disk you wish to share to the USB
1 port.