Xerox 92C NPS - Manual (Page 50)

PAPER AND OTHER SUPPLIES
A-6 XEROX DOCUPRINT 92C NPS SYSTEM OVERVIEW GUIDE
Other supplies
This section describes the supplies other than paper that are
necessary for installation and afterward. Your sales representative
will help you place your initial supply order.
Dry ink
Dry ink (also called toner) is the powder which forms the image on
the printed page. There are six cartridges of black dry ink or three
cartridges of colored dry ink in each carton. You should keep at least
one extra cartridge on hand at all times. The disposable cartridges
are easily changed with no mess. The consumption rate of Xerox dry
ink is approximately one cartridge per 30,000 pages for black dry ink
and 86,500 pages for colored dry ink. Use only dry ink that is
specified for use in the DocuPrint Model 92C printer, as described in
the consumable supplies table.
Note: Dry ink (toner) yields are based on 5% area coverage for
black dry ink and 1.5% area coverage for colored dry ink. Your yield
may vary, depending on coverage.
Fuser lubricant
Fuser lubricant is a consumable item required by the printer. You
should keep at least two boxes (each box contains two tubes) on
hand for installation by the service representative. The consumption
rate of Xerox fuser lubricant is approximately one tube per 120,000
pages. For product information, refer to the consumable supplies
table in this appendix.
Developer
Developer is not consumed by the printer but does have an effective
life of approximately 300,000 pages per bottle, guaranteed by Xerox.
Developer is a required item and must be kept on hand.
Use only the developer specified for use in your DocuPrint Model
92C printer.
For colored inks, use the color developer specified for each color in
the table below:
Table A-2. Developers for use with colored inks
Ink color Use developer Part number
Black Black 502S63250
Blue Blue 502S63252
Brown Consult your Xerox representative.
Cardinal Red 502S63251
Cyan Cyan 502S63992
Green Green 502S63253