Xerox 92C NPS - Manual (Page 14)

SYSTEM OVERVIEW
1-4 XEROX DOCUPRINT 92C NPS SYSTEM OVERVIEW GUIDE
•
PC 386 or 486, running MS-DOS, version 6.2, with one of the
following TCP/IP packages:
— PathWay Access 3.1, Wollongong Integrated Networking/
Transmission Control Protocol (WIN/TCP) for DOS, release
6.0
— FTP software, PC-TCP, release 3.0 or higher
— Sun Personal Computer–Network File Services (PC-NFS),
version 5.1
• IBM RS/6000 running IBM AIX, version 4.1
•
HP/Apollo running HP-UX, version 10.01
•
DECStation 5000/200 running DEC Ultrix, version 4.3
•
Apple Macintosh, System 7, 7.5, or 8.x, using AppleTalk
through EtherTalk, phase 1 or 2
• Any system that supports RFC-1179 lpr/lpd.
DocuPrint software may be compatible with workstation models and
software versions other than those listed above.
Client software
On your PC or workstation, you must install or set up a supported
means of submitting jobs to DocuPrint NPS. Depending on your
system, you can use the following:
• Xerox drivers for Windows 3.x, 95/98, or NT
•
Xerox Document Submission Software for DOS, Windows 3.x,
95/98, NT, or Macintosh
•
Third-party drivers
— Some PostScript drivers can be used in conjunction with
Xerox-supplied PPD files
— HP Color LaserJet for PCL 5c jobs
— HP LaserJet 4 for monochrome jobs
• Third-party TCP/IP lpd utility
•
Apple/Macintosh Printer Access Protocol (PAP)
The Xerox-provided software provides an interface with the Printer
Controller, which allows you to submit print jobs and check job status.
Note: The DocuPrint printing options available to a client user vary
according to the networking software loaded on the client
workstation.
For additional information on submitting jobs from a client
workstation, refer to the job submission documentation.