Zebra Technologies Mobile Printer - Manual (Page 20)

O-20
Cameo 2/3 Series User Guide
• Wireless printers associated with a LAN: refer to the RF
LAN Information section of the Self Test printout to verify
the printer’s SSID and IP addresses are correct, and that
the printer is “associated” with the wireless LAN.
• Invalid label format or command structure — use
Hex Dump Mode for troubleshooting. Refer to the
Programming Manual for more information.
Reduced battery charge life:
• Recondition (cycle) battery.
• Damaged battery-replace. Refer to Appendix D for
information on proper disposal of batteries.
• Check battery date code: if one to two years old, short
charge life may be due to normal aging.
Status light flashing and beeper chimes:
• No application: reload program.
Status light flashing
• If using IrDA or Bluetooth wireless communications:
normal indication data is being processed.
• If equipped with Magnetic Card Reader (MCR): indicates
reader is ready for a card swipe.
Status light always on:
• Check media is loaded and media compartment cover is
closed and latched.
Power Light Flashing
• Low battery warning
• Cameo 3 WLAN units: Printer‘s radio is not associated with
a WLAN access point.
Communication Error:
• Check media is loaded, media compartment cover is closed
and latched, and error light is off.
• Check baud rate.
• Replace cable to terminal.
Caution • Never use any sharp objects on the printer mechanism as it
could damage the printhead. Use only isopropyl alcohol, the supplied
cleaning pen and /or a cotton swab for cleaning the printer.