Zebra Technologies RW SERIES - Manual (Page 33)

33
RW Series User Guide
Compact Flash (802.11b) Radio Module
The following section only applies when the CF (Compact Flash) WLAN module (With
FCC ID: I28MD-RW4137) is installed in a RW series printer. The FCC ID number is on the serial number
label on the back of the printer and can be read with the module installed. Other than conditions specified
elsewhere in this manual, only one of the radio options can be installed in the printer at one time and the
antenna used for this transmitter must not be co-located or must not operate in conjunction with any other
antenna.
Caution • Use of a RW series printer with the radio module marked
with “FCC ID: I28MD-RW4137” meets the FCC requirements for
radio frequency (RF) radiation exposure in the standard body worn
configuration with no minimum separation. In this configuration, which
applies whether the belt clip or shoulder strap is used, the face of the
printer from which paper is transported is facing away from the user’s
body. The standard configuration must always be used when the printer
is body worn.
RW 220 printers with this radio option have been SAR tested. The
maximum SAR value measured for each model was 0.011527 W/g
averaged over 1 gram.
RW 420 printers with this radio option have been SAR tested. The
maximum SAR value measured for each model was 0.062 W/kg
averaged over 1 gram.
European Regulatory Information for this Radio
AT BE CY CZ DK
EE FI FR DE GR
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE GB
Note: -Member states in the EU with restrictive use for this device are
crossed out!
This device is also authorized for use in all EFTA member states (
CH, IS, LI, NO)
0336 Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU and
EFTA member states except in France where
restrictive use applies.
continued