Zebra Technologies RW SERIES - Manual (Page 32)

32
RW Series User Guide
Radio Regulatory Information
Bluetooth RW -ZBR3 Radio (RW 220 and RW 420)
Caution • Exposure to Radio Frequency Radiation.
The radiated output power of this internal Bluetooth radio is far below
the FCC radio frequency exposure limits. The internal Bluetooth radio
operates within guidelines found in radio frequency safety standards
and recommendations. Do not use the printer in an unauthorized
manner.
Note • The following section only applies when the RW-ZBR3 Bluetooth
Radio (FCC ID: I28MD-BTC2TY3) is installed in an RW series printer.
Unless specified elsewhere in this manual, the antenna used for this
transmitter must not be co-located or must not operate in conjunction
with any other antenna.
European Regulatory Information for the RW-ZBR3 Bluetooth Radio
This device is intended for use in all EU and EFTA member states.
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive
1999/5/EC. The following test methods have been applied in order to prove
presumption of compliance with the R&TTE Directive 1999/5/EC:
• EN 60950: 2000
Safety of Information Technology Equipment
• EN 300 328-2 V1.4.1 (2003-04)
Technical requirements for spread-spectrum radio equipment
• EN 301 489-1/-17 V1.4.1/1.2.1 (2002-08)
EMC requirements for spread-spectrum radio equipment.
This device is a 2.4 GHz wireless LAN transceiver, intended for indoor home and
office use in all EU and EFTA member states.
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU
and EFTA member states.