Zebra Technologies RW SERIES - Manual (Page 16)

16
RW Series User Guide
Fault
Fast Ch
arge
Fault
Fast Ch
arge
Fault
Fast Ch
arge
Ready
Power
Full Cha
rge
Ready
Full Cha
rge
Ready
Full Cha
rge
Full Cha
rge Fault
Fast Ch
arge
Ready
Figure 7: UCLI72-4 Quad Charger
Charging will cease three (3) hours after the charger has entered the
“Maintain” mode.
Model UCLI72-4 Quad Charger
The UCLI72-4 Quad Charger is designed to charge up to four
RW Series battery packs simultaneously. Batteries must be
removed from the printer to be charged in the Quad Charger.
1. Ensure that the charger has been installed properly per
the Quad Charger instruction manual. Ensure that the
power indicator on the front panel is on.
2. Remove any protective shrink-wrap and labels from all
battery packs prior to use. Plug a battery pack into any
one of the four charging bays as shown in Figure 7, noting
the orientation of the battery pack. Slide the battery pack
into the charging bay until it stops. Then rock the battery
pack back until it snaps into place. The amber indicator
Amber
LED
Green
LED
2. Rock Battery Pack into
place
1. Slide Battery Pack into Charger
Bay
Power Indicator
Power
Charger Bay