Yamaha CLAVINOVA C L P - 3 8 0 - Manual (Page 108)

CLP-380 Owner’s Manual 108
Detailed Settings
Questions about Operations and Functions
■ The buttons do not respond.
While you are using a function, some buttons not used
for the function are disabled. If the song is playing, stop
the playback. Otherwise, press the [EXIT] button to
return to the main screen. Then, perform the desired
operation.
■ The sound sustains indefinitely and does
not decay when I press the sostenuto
pedal.
With the voices in the CHURCH ORGAN, JAZZ
ORGAN, STRINGS, CHOIR group, or some voices in the
XG group, the sound continues sustaining while you are
holding down the sostenuto pedal.
■ Higher or lower notes does not sound
correctly when the transpose or octave
setting is made.
The setting range for the transposition and octave setting
is C -2 – G8. (With the normal setting, the Clavinova’s 88
keys covers the range of A -1 – C7.) If the lowest key is set
to a note lower than C -2, it will produce a sound one
octave higher. If the highest key is set to a note higher
than G8, it will produce a sound one octave lower.
■ How can I return to the recording or song
select screen during song recording or
playback?
Press the [SONG SELECT] button once.
■ The tempo does not change even though
I recorded with tempo changes.
Depending on the timing of tempo changes, the changed
tempo may not be recorded. In this case, the recording
will be played back at the original tempo.
Make tempo changes when the recording part is selected
and a red part indicator is flashing. The same trick applies
to editing the tempo after recording.
■ Performance in Dual or Split mode is not
recorded.
Part data is lost unexpectedly.
For Dual or Split mode recording, the recording part for
the second voice (that is, the voice for the left-hand part)
is automatically assigned (page 27). Therefore, if the part
already has data, the data will be overwritten during
recording. Also, switching to Dual mode or Split mode in
the middle of the song is not recorded. Therefore, the
notes you played with the second voice (or the notes
lower than the Split point) are not recorded.
What type of data is recorded?
Data recorded in the parts:
• Note data (notes you play)
• Voice selection
• Clavinova pedals and external pedal on/off
• Reverb depth [ReverbSend]
• Chorus depth [ChorusSend]
• DSP effect depth [DSPDepth]
• Sound brightness [Brightness]
• Resonance effect setting [HarmonicContent]
• Equalizer’s low-range frequency setting [EQLowFreq.]
• Equalizer’s low-range gain setting [EQLowGain]
• Equalizer’s high-range frequency setting [EQHighFreq.]
• Equalizer’s high-range gain setting [EQHighGain]
• Octave setting of the voice [Octave]
• Volume setting of each voice [Volume]
• Left/right position of each sound [Pan]
• Fine pitch adjustment between two voices (Dual only)
[Detune]
• Volume change in response to playing strength for each voice
[TouchSense]
Data recorded globally in all parts:
• Tempo
• Time signature
• Reverb type
• Chorus type
• DSP effect type
You can change all data except for note data, Octave
setting or Time Signature after recording.