Xerox WorkCentre Pro 75 EN - Manual (Page 78)

Page 64 Xerox WorkCentre Pro/CopyCentre User Guide
Using Build Job and Sample Set
Typical Application
Produce multiple sets of a document where individual
segments require unique feature programme selections.
Procedure
1. Load the originals for the first job segment.
2. Depending on the configuration of your machine press the
More Copy Features tab or the Job Assembly tab. If the
More Copy Features tab is selected press the Job
Assembly tab.
3. Press Build Job then press the Build Job On button. Press
the Save button. Select Sample Set and Save to produce
a single complete set for review.
4. Press the Basic Copy tab and programme the appropriate
features for the first segment of the job.
5. Press the Start ( ) button.
6. Repeat this procedure for each remaining segment.
7. After the final segment has been scanned press Build Job
Controls then press End Build Job.
A single review set will be produced because Sample Set
was selected.
8. After you review the initial set, press the Job Status ( )
button to display a listing of queued jobs.
9. Touch your job to select it.
10. If you are satisfied with your initial set press Release.
Otherwise, delete it and start again.