Yamaha DSP-AX2 EN - Manual (Page 51)

English
49
Remote Control Features
Changing the Source Name in the Display Window
1 1 Select the source component you want to rename by using
the input buttons.
2 2 Press RE-NAME using a ballpoint pen or similar object.
3 3 Use the cursor buttons h/g to select a character.
• Pressing g changes the character in the following order:
A~Z, a~z, 0~9, space, -(hyphen), /(slash).
4 4 Use the cursor buttons q/w to enter a character or move to
the next cursor postion.
5 5 Press RE-NAME to confirm renaming.
• If you want to rename another source component
immediately, press ENTER and repeat steps 1, 3 and 4.
Clearing a Learned Function or Macro
1 1 Select the source component that you want to clear on the
window by using input buttons.
2 2 Press LEARN if you want to clear a learned function, or
press MACRO to clear a programmed macro, using a ball
point pen or similar object.
3 3 Press and hold CLEAR using a ball point pen or similar
object, and at the same time press the button from which you
want to clear the learned function or macro for about 3
seconds.
• “C:NG” appears in the display window if the operation is
unsuccessful. Should this occur, try doing step 3 again.
You can clear other learned functions and macros at this
time by continuing to hold down
CLEAR and pressing the
other buttons on which those learned functions or macros are
programmed.
4 4 Press LEARN again to confirm clearing a learned function,
or press MACRO again to confirm clearing a programmed
macro.
• Once you clear a learned function or macro from a button,
the button reverts to its factory preset function or macro.
RE-NAME
MACRO
LEARN
Flashes
alternately
or
or
CLEAR
Flashes
alternately
While pressing
MACRO
LEARN
or
RE-NAME