Yamaha DSP-AX2 EN - Manual (Page 36)

Introduction
Preparations
Basic Operation
Advanced Operation
Additional
Information
Appendix
34
SET MENU Items
■ 1D. REAR CT SP (Rear Center Speaker Mode)
By adding a Rear Center speaker to your speaker configuration, this unit can provide more realistic front-to-back and back-to-front
transitions. The initial setting is “LRG”.
Select the “LRG” setting if you have a large Rear Center speaker. The entire range of Rear Center channel signals is sent to the Rear
Center speakers.
Select the “SML” (small) setting if you have a small Rear Center speaker. Rear Center channel low frequency signals of 90 Hz and
below are distributed to speakers selected with the 1E. LFE/BASS OUT item.
Select the “NONE” setting if you do not have a Rear Center speaker. The Rear Center signal is directed to the Rear L/R speakers.
■ 1E. LFE/BASS OUT (Bass Output Mode)
LFE signals carry low frequency effects when this unit decodes DTS or Dolby Digital signals. Low frequency signals are defined as
90 Hz and below. The initial setting is “BOTH”.
Select the “SWFR” (Subwoofer) setting if you use a Subwoofer. The LFE signals are directed to the Subwoofer.
Select the “MAIN” setting if you do not use a Subwoofer. The LFE signals are directed to the Main speakers.
Select the “BOTH” setting if you use a Subwoofer and you want to mix the Main channel low frequency sound signals with the LFE
signals.
Note:
• The low frequency signals of 90Hz and below from all Main, Center, Rear, and Rear Center channels are directed to the LFE channel when you select
the small speaker setting in items 1A, 1B, 1C, and 1D.
■ 1F. FRNT EFCT SP (Front Effect Speaker Mode)
This unit uses Front Effect speakers to localize the virtual sound sources of the sound field programs. If you do not use Front Effect
speakers, you can direct the Front Effect signals to the Main speakers.
The OSD shows small or no Front Effect speakers depending on how you set this item. The initial setting is “YES”.
Select the “YES” setting if you use Front Effect speakers.
Select the “NONE” setting if you do not use Front Effect speakers. The Front Effect signals are mixed with the Main channels.
1D REAR CT SP
“LRG SML NONE
1D REAR CT SP
LRG “SML NONE
1D REAR CT SP
LRG SML “NONE
1D REAR CT SP
“LRG
SML NONE
Large Small None
1E LFE/BASS OUT
SWFR MAIN“BOTH
1E LFE/BASS OUT
“SWFR MAIN BOTH
1E LFE/BASS OUT
SWFR“MAIN BOTH
1E LFE/BASS OUT
SWFR MAIN“BOTH
Subwoofer Main Both
1F FRNT EFCT SP
“YES NONE
1F FRNT EFCT SP
“YES NONE
1F FRNT EFCT SP
YES “NONE
YES NONE