Xerox 701P40211 - Manual (Page 13)

Common Controller 2-1
2. Gateway Configuration
Setting up the HTTP and SNMP gateways cannot be
accomplished through the graphical user interface and must be
set using the gwConfig utility through a UNIX Terminal window.
The IPP gateway is configured using the DocuSP interface.
Internet Services (HTTP) Gateway Configuration
Perform the following to configure the HTTP gateway:
1. Start the configuration utility. Type ./ gwConfig.
NOTE: Refer to the instructions in the section, IPP Gateway
Configuration for information about starting the configuration.
2. Perform the following to set up the Internet Services (HTTP)
Gateway:
Enter the name of the gateway to be configured: Internet
Services
Configure the Internet Services Gateway? [Y/N] y
Enter name: Value data
Printer URL: http://.name>.com
NOTE: Use the IP address of the controller if there is no
domain name. For example, http://52.126.255.255.com
3. A confirmation message of the entered value displays.
Confirm that the entry is correct and enter y for yes.
4. Continue with this process for every value to be configured.
5. When all of the desired values have been configured, press
at the Enter Name: [Value Data line].
6. When asked to accept the values and update the
configuration, enter y for yes.
7. The configuration utility exits.