Yamaha CD Recordable/Rewritable Drive CRW2200S - Manual (Page 54)

E-IDE (ATAPI) Connection Set Up
46
10 10 10 10 Connect a 4-pin power cable to the power supply connector of the
CRW2200E marked “DC INPUT.”
Notes
• There may be more than one 4-pin power cable available. Any one may be used.
• These connectors are D-shaped, so you can only connect the power cables in the correct
orientation. Do not apply excessive force when making this connection.
11 11 11 11 Tighten the four fastening screws on the side of the unit securely using a
phillips screwdriver. (→ → → →P. 28 step 15 15 15 15)
12 12 12 12 Attach the outer casing and all cables and peripheral devices of the
computer and any screws that were removed. (→ → → →P. 29 step 16 16 16 16)
13 13 13 13 Reconnect the computer to the AC outlet and turn it on.
(→ → → →P. 29 step 17 17 17 17)
When you turn on the computer, make sure the LED on the panel of the
CRW2200E blinks in green, which indicates that it is reading disc information.
(
→ P. 60)
4-pin power cable
Bottom
Top
DC INPUT
connector