Yamaha CD Recordable/Rewritable Drive CRW2200S - Manual (Page 28)

SCSI Connection Set Up
20
Setting the Jumper Switches
8 8 8 8 Before fitting the CRW2200S into the computer, you need to set up the
drive using the jumper switches located at the rear of the unit. You’ll
need to set the following:
➀
SCSI ID number
➁ Parity check
➂ Termination
➃ Block size
To set each jumper switch, you have to bridge the two pins in the respective
column of the grid with a plastic shunt. Shunts are already attached to the jumper
switches in their default configurations.
Note
The plastic shunts actually contain metal for bridging the two pins of a jumper switch,
creating an electrical connection between them when attached. When removed, the jumper
switch is set to “OFF.” Store unused shunts in a safe place where they will not be lost.
Use a pair of long-nosed pliers to attach or detach the plastic shunts
accordingly. Make sure that the computer is turned off beforehand.
ID SELECT
PARITY.
TERMINATOR
BLOCK SIZE
1 2 4
Jumper switches
Rear Panel