Yamaha CD Recordable/Rewritable Drive CRW2200S - Manual (Page 29)

SCSI Connection Set Up
21
➀ SCSI ID Number
Each of the SCSI devices connected to the computer is identified by its SCSI ID
number. You need to assign a number from “0” to “7” for each SCSI device.
Commonly, ID number “7” is reserved for the computer’s SCSI card itself.
Therefore, the CRW2200S can actually be assigned an ID number from “0” to
“6.” The ID number is set by attaching/detaching the shunts on the ID Select
jumper switches according to the diagram shown below.
Note
The SCSI ID number for each device on the chain must be unique. Make sure the
CRW2200S’s SCSI ID number is not the same as that of any other device on the chain. By
factory default, the CRW2200S is assigned ID number “3” but this can be changed.
D SELET
PARITY
TERMINATOR
BLOC SIE
1 2 4
D SELET
PARITY
TERMINATOR
BLOC SIE
1 2 4
D SELET
PARITY
TERMINATOR
BLOC SIE
1 2 4
D SELET
PARITY
TERMINATOR
BLOC SIE
1 2 4
D SELET
PARITY
TERMINATOR
BLOC SIE
1 2 4
D SELET
PARITY
TERMINATOR
BLOC SIE
1 2 4
D SELET
PARITY
TERMINATOR
BLOC SIE
1 2 4
D SELET
PARITY
TERMINATOR
BLOC SIE
1 2 4
SCSI ID 6 SCSI ID 7
SCSI ID 3 (Default) SCSI ID 4 SCSI ID 5
SCSI ID 0 SCSI ID 1 SCSI ID 2