Yamaha CD Recordable/Rewritable Drive CRW2200S - Manual (Page 19)

Front and Rear of Unit
11
➀ DIGITAL AUDIO OUT connector
If your sound card has a SPDIF (digital audio) input connector, you can connect the
DIGITAL AUDIO OUT connector of the unit to the SPDIF connector using a digital audio
cable (sold separately). (
→ P. 17, 45)
➁ ANALOG AUDIO OUT connector
Connect one end of the 4-pin audio cable to this and the other end to your computer’s
sound card or built-in audio. (
→ P. 16, 44)
➂ Jumper switch
Plug a plastic shunt into this jumper switch to select the connection, either IDE master or
slave. The CRW2200 drive’s factory setting is SLAVE. (
→ P. 42)
➃ IDE INTERFACE CONNECTOR
Insert the connector of the IDE cable here. ( → P. 43)
➄ DC INPUT connector
Insert the power connector from your computer’s power supply in this socket to feed power
to the drive. (
→ P. 46)
Rear Panel (without the SCSI Convertor)
➁ ➀ ➂ ➃ ➄