Yamaha CD Recordable/Rewritable Drive CRW2200S - Manual (Page 24)

SCSI Connection Set Up
16
Audio cable connection
Yamaha recommends connecting the audio cable before installing the SCSI
convertor for easy connecting.
4 4 4 4 Connect the audio cable to the CRW2200 drive. (If necessary)
You can play audio CDs on the CRW2200S and hear it through your computer’s
sound card.
Notes on playing audio CDs
• Audio is available from the headphones or speakers connected to the headphone jack
located on the front panel of the CRW2200S (this is convenient if you have no sound card
in your computer). In this case, you do not need to connect an audio cable.
• When creating an audio CD, if you use the SCSI flat cable to send the signal, you do not
need to connect an audio cable.
• If you use the CRW2200S as a supplemental drive for the unit, and the CD-ROM drive or
DVD-ROM drive is already connected to the sound card, YAMAHA recommends you
playback audio CDs using the existing drive.
There are two methods of connecting the unit and the sound card: an analog
connection and a digital connection.
Connecting the analog audio cable
Connect one end (the end which has one connector) of the included audio cable to
the ANALOG AUDIO OUT connector on the rear panel of the CRW2200 drive.
Make sure to check the connector direction according to the figure below.
Audio cable
Left (L)
Ground (G)
Right (R)
ANALOG AUDIO
OUT
(to Sound card)