Yamaha CD Recordable/Rewritable Drive CRW2200S - Manual (Page 30)

SCSI Connection Set Up
22
➁ Parity Check
The parity check is used for error correction during data transmissions. If parity-
checking has to be disabled, the shunt on the Parity jumper switch should be
removed.
Note
By factory default, the Parity switch is set to “ON” and should normally be left in this state.
➂ Termination
Terminators prevent SCSI signals from being reflected off the last device in the
chain. The SCSI terminator switch should be set to “ON” if the CRW2200S is
the last device on the internal SCSI chain. If the CRW2200S is not the last device
on the internal SCSI chain, the shunt on the Terminator jumper switch should be
removed.
ID SELECT
ARTY
TERMINATOR
BLOC SIE
ID SELECT
ARTY
TERMINATOR
BLOC SIE
1 1 2 2 4 4
Parity ON (Default)
Normally leave this
setting alone.
Parity OFF
The setting allows for the parity
checking. Normally, set PARITY
to ON to enable error correction. The setting does not
allow for parity
checking.
CRW2200S
(terminated)
SCSI card
Hard disk drive
(unterminated)
Computer
MO drive
(terminated)
Terminator