ZyXEL Communications 792H - Manual (Page 355)

Prestige 792H G.SHDSL Router
Firmware and Configuration Maintenance 31-9
31.3.2 Restore Using FTP Session Example
Figure 31-8 Restore Using FTP Session Example
Refer to section 31.2.5 to read about configurations that disallow TFTP and FTP over WAN.
31.3.3 Restore Via Console Port
Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1. Display menu 24.6 and enter “y” at the following screen.
Figure 31-9 System Maintenance – Restore Configuration
Step 2. The following screen indicates that the Xmodem download has started.
Figure 31-10 System Maintenance – Starting Xmodem Download Screen
Step 3. Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...
CCCCCCCCC