ZyXEL Communications NWA3160 - Manual (Page 171)

Chapter 14 Remote Management Screens
ZyXEL NWA-3160 Series User’s Guide
171
Figure 107 Remote Management: SNMP
The following table describes the labels in this screen.
Table 66 Remote Management: SNMP
LABEL DESCRIPTION
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and
allows all requests.
Set Community Enter the Set Community, which is the password for incoming Set requests
from the management station. The default is public and allows all requests.
Trap Destination Type the IP address of the station to send your SNMP traps to.
SNMP Version Select the SNMP version for the ZyXEL Device. The SNMP version on the
ZyXEL Device must match the version on the SNMP manager. Choose SNMP
version 1 (SNMPv1), SNMP version 2 (SNMPv2) or SNMP version 3 (SNMPv3;
NWA-3165 only).
Trap Community Type the trap community, which is the password sent with each trap to the
SNMP manager. The default is “public” and allows all requests.
This field is available only when SNMPv1 or SNMPv2 is selected in the SNMP
Version field.
User Profile
(NWA-3165 Only) This field is available only when you select SNMPv3 in the SNMP Version field.
When sending SNMP v3 traps (messages sent independently by the SNMP
agent) the agent must authenticate the SNMP manager. If the SNMP manager
does not provide the correct security details, the agent does not send the traps.
The ZyXEL Device has two SNMP version 3 login accounts, User and Admin.
Each account has different security settings. You can use either account’s
security settings for authenticating SNMP traps.
Select User to have the ZyXEL Device use the User account’s security settings,
or select Admin to have the ZyXEL Device use the Admin account’s security
settings.
Use the Configure SNNMPv3 User Profile link to set up each account’s
security settings.