Zoom ADSL USB Modem Quick Start guide None - Manual (Page 19)

19
6666
Click the Configuration tab, then enter the VPI and VCI
numbers in the corresponding ATM Channel VPI and ATM
Channel VPI boxes, select the Encapsulation Type from the
drop-down list, and click Save Changes. Do not change any
other fields. Restart your computer if you are prompted to do
so.
Note:
If you do not know your ADSL service provider’s settings,
refer to the tables beginning on page 27 or contact your service
provider.
7777
What happens next depends on the type of Encapsulation you
selected in the step above.
! If you selected Bridged or Routed: No additional
configuration is usually required. Go to Step 8.
! If you selected PPP: From the Apple menu, select
Control Panel and then Remote Access. Then enter the
Username and Password your ADSL service provider
gave you, and click Connect.
Note:
If you change your Encapsulation settings in the ADI monitor
from this point on, you must unplug your modem’s USB cable
and then plug it back in after you restart your computer.
8888
Verify that your Internet connection is working. Open your
Web browser (i.e., Internet Explorer or Netscape Navigator)
and try to connect to a familiar Web address.
If you connect successfully, your installation is complete
and you are ready to browse the Web!
If you did not connect, see Connection Troubleshooting
Tips on page 20.