Zoom ADSL USB Modem Quick Start guide None User Manual

Page 17

9999

What happens next depends on the type of encapsulation you
selected above.
! Bridged or Routed: No additional configuration is

usually required. Go to Step 10.

! PPP:

—You must change the highlighted entry in the Show

pulldown list from Internal Modem to Ethernet

Adaptor. If you see two Ethernet Adaptor entries, select

the first one. The screen will change so that the Configure

pulldown entry says Using PPP. If it says Using DHCP,
select the second Ethernet Adaptor entry to force the

change to take effect.

–-At the TCP/IP tab, click the PPPoE tab and then click

checkbox labeled Connect Using PPPoE.

Important! This tab and checkbox covers both PPPoE

and PPPoA, so click it if you are using either type of PPP.

Then enter the Username (Account Name) and

Password your service provider gave you, and click Apply
Changes.

-Click the Internet Connect icon from the Dock, select

Ethernet Adaptor from the Configuration pulldown list,

and click Save Changes.

Verify that your Internet connection is working. Open
your Web browser (i.e., Internet Explorer or Netscape

Navigator) and try to connect to a familiar Web address.
If you connect successfully, your installation is

complete and you are ready to browse the Web!
If you did not connect, see Connection Troubleshooting

Tips on page 20.