ZyXEL Communications P-2900-4HB - Manual (Page 23)

Chapter 2 Introducing the Web Configurator
P-2900-4HB User’s Guide
23
2.2.1 Resetting the ZyXEL Device
If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the ZyXEL Device to reload the factory-
default configuration file. This means that you will lose all configurations that you
had previously and the password will be reset to “1234”.
2.2.1.1 Using the RESET Button
1
Make sure the PWR LED is on (not blinking).
2
Press and hold the RESET button for about 15 seconds. All LEDs should turn on.
When you release the RESET button, the defaults have been restored and the
ZyXEL Device restarts.
You can also use the RESET button to restart the ZyXEL Device (without restoring
the defaults) by pressing down for 2 to 14 seconds.
2.3 Navigating the Web Configurator
The following section summarizes how to navigate the web configurator from the
main Status screen.
Figure 6 Status