Xerox 8560 - Manual (Page 67)

Printing on Specialty Media
Phaser® 8560/8860 Printer
3-31
Printing on Specialty Media
This section includes:
■ Printing Transparencies on page 3-31
■ Printing Envelopes on page 3-38
■ Printing Labels on page 3-45
■ Printing Glossy Paper on page 3-51
■ Printing Custom Size Paper on page 3-57
Printing Transparencies
Transparencies can be printed from any tray. They should be printed on one side only. Use
only recommended Xerox transparency film.
To order paper, transparencies, or other specialty media, contact your local reseller or go to the
Xerox Supplies website for your printer:
■ www.xerox.com/office/8560Psupplies (Phaser 8560 printer)
■ www.xerox.com/office/8860supplies (Phaser 8860 printer)
Caution: Damage caused by using unsupported paper, transparencies, and other specialty
media is not covered by the Xerox warranty, service agreement, or Total Satisfaction
Guarantee. The Total Satisfaction Guarantee is available in the United States and Canada.
Coverage may vary outside these areas; please contact your local representative for details.
See also:
For the Phaser 8560 printer:
Recommended Media List (United States)
Recommended Media List (Europe)
For the Phaser 8860 printer:
Recommended Media List (United States)
Recommended Media List (Europe)
Guidelines
■ Remove all paper before loading transparencies in the tray.
■ Handle transparencies by the edges using both hands. Fingerprints or creases can cause
poor print quality.
■ Do not load more than 50 transparencies in Tray 1. Do not load more than
400 transparencies in Trays 2-4. Overloading the tray can cause the printer to jam.
■ Do not use transparencies with stripes on the side.
■ After loading transparencies, change the paper type at the control panel ( Printer Setup /
Paper Handling Setup ).