Xerox 8560 - Manual (Page 126)

Moving and Repacking the Printer
Phaser® 8560/8860 Printer
5-18
3. Within 10 seconds after turning off the printer, select Shut Down for Moving Printer on
the control panel.
Note: If you receive a Power Down Error-Head not Parked message at the control
panel, the printer is not ready to be moved. If the printhead is not locked, the printer can be
damaged during shipment.
4. Verify that the flag in the exit tray is in the raised position. When the flag is raised, the
printhead is locked.
5. Wait for the printer to complete the cool-down period for the ink to solidify. The fan shuts
down when it is cool enough to move.
Caution: If you turn off the printer but do not select Shut Down for Moving Printer on
the control panel, the fan does not run, so you must wait longer for the ink to solidify. Wait
at least 30 minutes for the printer to cool completely before moving or packing it.
6. Unplug the printer after the cool-down cycle is complete.
7. Use the hand holds on each side of the printer to lift it. Move the printer separately from
the 525-Sheet Feeder.
8860p-099
28 kg
60 lb.